phone envelop google-plus3
View structural bearing pad CV/CA image 1 View structural bearing pad CV/CA image 1-1
View structural bearing pad CV/CA image 2 View structural bearing pad CV/CA image 2-2
View structural bearing pad CV/CA image 3 View structural bearing pad CV/CA image 3-3

TICO CV/PF Structural Bearing Pad

TP-009004

TICO CV/PF is a very high stress structural bearing seating, manufactured from press cured laminates of heavy duty synthetic rubber proofed fabric and is usually specified for arduous and very high stress applications. CV/PF is a popular solution to the problem of structural damage caused by shrinkage, rotation, differential settlement and localised stresses.

Key Features:

  • Great durability.
  • Impact absorption
  • Maximum recommended working stress 15.5 MN/m2
  • Retention of properties under extreme conditions with a long service life
  • Can be made with different make ups for specific custom applications
  • Durable temperature range (°C) -40 to +70

Standard Structural Bearing Pad Sizes

  • 1200 mm x 75 mm Structural Bearing Pad
  • 1200 mm x 150mm Structural Bearing Pad
  • 1200 mm x 300 mm Structural Bearing Pad
  • 1200 mm x 600 mm Structural Bearing Pad
  • 1200 mm x 1200 mm Structural Bearing Pad
  • 1200 mm x 75 mm Structural Bearing Pad
  • 1200 mm x 150mm Structural Bearing Pad
  • 1200 mm x 300 mm Structural Bearing Pad
  • 1200 mm x 600 mm Structural Bearing Pad
  • 1200 mm x 1200 mm Structural Bearing Pad
  • 1200 mm x 75 mm Structural Bearing Pad
  • 1200 mm x 150mm Structural Bearing Pad
  • 1200 mm x 300 mm Structural Bearing Pad
  • 1200 mm x 600 mm Structural Bearing Pad
  • 1200 mm x 1200 mm Structural Bearing Pad
  • Related Products

    Structural Bearing Pad TICO CV/M

    CV/M

    Structural Bearing Pad TICO CV/CA

    CV/CA

    Structural Bearing Pad TICO CV/D

    CV/D

    More Details

    Installation: The surface on to which the resilient seating is to be bonded should be level, clean and flat. Suitable adhesive should be used and the seating held firmly in place until the correct bond strength is achieved. Pre-cast beams and slabs may be placed directly onto resilient seatings.


    If a joint or slab is to be cast in situ, then it is important to ensure that no concrete is allowed to bridge the restraint barrier. It is suggested that this can be achieved by either employing TICO Void Filler or temporarily by infilling with compacted sand and sealing with polythene prior to casting the concrete.


    Non-Standard sizes and thicknesses are available on request. TICO CV/PF Structural Bearing Pads can be supplied with a protective Hypalon lacquer edge proofing if required.

    • There were some problems with your form submission:

    Please check your inbox for CV/PF Datasheet - Please note: Some email providers will block our correspondence, if this happens contact us using details provided on our website.